Roper Washer Repair Near Me in The Strip & East Paradise, Clark County, NV

Roper builds its washers around top-load agitator designs with mechanical timers, and that design decides where faults tend to appear. Roper machines are mechanically simple, and most repairs involve inexpensive, widely shared Whirlpool parts.

A tub full of water at the end of the cycle is a common complaint, and on Roper units it typically comes down to a clogged drain pump filter, a kinked drain hose or a failed drain pump. With Roper washers, a full tub that never starts spinning most often means a lid switch or door lock that isn't confirming, an off-balance load or a worn belt or motor coupling. Slow filling or a fill error on a Roper washer generally traces back to inlet hose screens clogged with mineral scale or a weak water valve. Beyond the faults every washer shares, Roper models have their own weak spots: lid switch faults, timer faults and belt and coupling wear.

With a Roper washer, start with the simple things. Check that the drain hose isn't pushed too far into the standpipe or kinked behind the machine. On a front-loader, drain and clean the pump filter behind the small access panel, with towels down first. Use only the HE detergent dose the machine calls for; extra suds cause errors of their own. Unplug the washer and shut off the water before pulling it out or opening any panel.